How to Take Springs off a Trampoline? The best guide!

I’m going to show you how to take springs off a trampoline. There are many reasons why you might want to remove the springs, but I will only be discussing how to do it in this blog post. The first thing that you need is a screwdriver and an Allen wrench. You can find some of these tools at your local hardware store or on Amazon for pretty cheap, so if you don’t have them at home already then it’s worth picking up a set before starting the process because removing the springs takes some time and effort.

Step by step on how to Take Springs off a Trampoline

Below are the steps you need to know on how to take springs off a trampoline easily. It has been remarkably broken down to a level that you can understand each of the steps with or without a Youtube tutorial on how to take springs off a trampoline. Once you have the tools, follow these steps on how to Take Springs off a Trampoline:

Step 1:

First, unscrew the bolts on each end of where the spring is attached. Make sure that both sides are completely undone before proceeding with step two because it’s very difficult to get them back in place once they’re loosened up. Now, find the Allen wrench. You will notice a threaded rod sticking out of one side that can be unscrewed with your hand and an Allen wrench on the other end where you should have removed all four bolts from earlier.

Step 2:

Once both sides are loosened up enough, use the Allen wrench to unscrew the threaded rod, and then pull it out. Once you have both sides completely removed, flip the trampoline over so that the springs are on top of each other. You should be able to see how they connected at either end in their original position because one side has a hole where an Allen wrench can go through to attach it to the frame and one side has a hole where screws can be inserted.

Step 3:

Now, feed them through so that they come out of the opposite end into two loops on top of each other (if you were able to see how they connected before). Once you have done this, use the screwdriver to poke a hole through one of them. Now, feed both loops into that hole you poked so they come out on either side, and then tie each end together. After this, cut off any excess wire with the scissors or wire clippers until it is barely hanging down from where your knot was tied.

Step 4:

The last thing you need to do is put the bolts back in place and tighten them up. Start with one, then move on to the other, making sure that they are both tight before moving on to step two. Once both of those have been tightened all the way down, reattach your end caps which will cover up the holes and keep your trampoline nice and safe for use. You can be very comfortable after this last step because it will be good.

Conclusion on how to Take Springs off a Trampoline

With the above guide that we have provided you with the step-by-step on how to make springs off a trampoline, it will be easier for you to take offspring from any trampoline. However, the different trampolines may come with different step by step on how to achieve the same thing. You should bear in mind that whether the choice of a trampoline comes with its own guide or not, it will almost be similar to what you have read in this article. You can check more on how to clean your trampoline.